Rear End Installation Kits G-Force provides rear end installation kits with the parts you always need, but can never find. Installation kits include complete shim assortments, pinion seal, pinion nut and washer, special ring gear bolts, pinion preload spacer, gasket, gear marking compound, ProLock, silicone sealant and helpful setup tips. Contents vary depending on the application and kits are available with or without pinion and carrier bearings.

Chrysler: Part# GF1031 GF1034 GF1037 GF1070 Application 8-3/4" 489 casting 1969-73 Dana 60 8-3/4" 742 casting 1957-69 Dana 70   Ford: Part# GF1045 GF1015 GF1043 GF1011 GF1011C-1 GF1011C-2 GF1011C-3 GF1011C-4 GF1011C-5 Application 7.5" 8.0" 8.8" 9.0" 9.0" Standard 2.879 Carrier 9.0" Daytona 2.879 Carrier 9.0" Daytona 3.062 Carrier 9.0" Standard 3.062 Carrier 9.0" 35-spline aftermarket   General Motors: Part# GF1010 GF1016 GF1018 GF1019 GF1020 GF1021 GF1022 GF1040 GF1042   GF1044   Application Corvette 1963-79 7.5" 10 Bolt 1977-81 Truck 12 Bolt Passenger Car 12 Bolt 8.5" 10 Bolt Truck 8.5" 10 Bolt (Rear) 8.2" C-Clip 10 Bolt 8.2" B or P Axle 10 Bolt 9.3" C Axle 1957-64 Olds/Pontiac 7.5" 10 Bolt 1982-91   Kit Variations Available: GFxxxxB GFxxxxF Basic Kit Full Kit   Concentricity Checking Gauge   1350 Billet Yoke for a Ford 9" Center Section

Lubricants To ensure maximum performance and proper lubrication of gears and bearings in all G-Force Transmissions, use G-Force specially formulated GF-2000 Transmission Oil. This lubricant will hold up to extreme temperatures while maintaining the correct viscosity. Transmission Adapters Adapters are available to convert G-Force Transmissions to any engine/bell-housing arrangement. G-Force Racing Apparel Like our line of transmissions and shifters, our Racing Apparel is constructed of the highest quality materials.

		Spicer 1330 u joint 5-618X same as 5-1330X
	To inquire, contact Kevin at GFS via email at kevinstewart@earthlink.net or call 1-336-625-3844